衛生間漏水是件很棘手的事情，廁所衛生間用水頻繁，防水處理不好就合出現滲漏水，其主要現象有樓板管道滴漏水、地面積水、墻壁潮濕、滲水，甚至下層頂板和墻壁也出現潮濕滴水現象。那么遇到衛生間漏水應該采取哪些措施呢？
1、將表面的灰塵、油污、積水等處理干凈，并保持表面干燥；
The processing surface dust, oil, water and other clean, and keep the surface dry;
2、在能淋到水的整個面，如：瓷磚面、瓷磚縫、墻縫、管根等部位，噴刷滲透型防水劑，不可漏噴；
In the energy poured into the entire surface of the water, such as: tile surface, tile joints, Qiang Feng, roots and other parts of the tube, stencilled permeable waterproofing agent, can not leak spray;
3、防水劑表面干以后，用防水膏填實所有瓷磚縫、及破損和缺陷部位；
After the waterproofing agent surface dry with waterproof cream tamped all tile joints, and damaged and defective parts;
4、對墻角、墻邊、管根等薄弱環節，用云禹塑鋼泥封邊加固。
Right corner, wall, pipe root and other weak links, with cloud Yu plastic mud Edge reinforcement.
5、如果需要更換衛生間原有地磚，將原有地磚鑿去后，一定要先做基面的清潔然后用水泥砂漿將地面找平，再做防水處理。
If you need to replace the original bathroom tiles, the original floor tiles chipped away, we must do first and then clean the base surface of the ground with cement mortar leveling, do water treatment.
6、衛生間的水氣比較大。目前一般的樓房都是衛生間和浴室是一體的，所以衛生間經常會被水蒸氣包圍，因此棚頂的防潮非常重要。做衛生間棚頂防水，最好在棚頂涂抹一層水玻璃，然后采用防水性能較好的PVC扣板。扣板可以安裝在龍骨上，還能起到遮掩管道的作用。
Toilet water vapor is relatively large. Current general buildings are toilets and bathrooms are one, so the bathroom is often surrounded by water vapor, so the roof of moisture is very important.Do toilet roof waterproof, preferably water glass roof smear layer, then use a good waterproof PVC panel. Pinch can be mounted on the keel, but also play a role in the pipeline cover.
7、防水施工結束后，要求防水材料實干后(通常48小時后)方可淋水。因為運輸過程中顛簸不斷，防水膏會有沉淀，表面看起來會有些干，屬正常現象!在開封前要多揉捏一會，讓防水膏充份膏化。
After the waterproof construction, requiring waterproof material (usually after 48 hours) after the hard work before watering. Because constantly bumps during transport, waterproof cream will precipitate, the surface looks somewhat dry, is a normal phenomenon! Before opening to more kneading in a while, let the cream fully waterproof cream.
